Sunday, November 8, 2009

note:

-as suggested by Engineer Harold Gayeta MBI(MEGAPIPE BUILDERS INC.), metal sheet cutters were used for shorter cuts(75mm and below).. as illustrated in the following pictures, we are referring to the horizontal cuts which are approximately 50mm in length.. same length as the ecosan waterline pipes.. too short to use the baby/angle grinders so we used metal sheet cutters instead.. faster and cheaper..

Ed pls advise..








Posted by at

1 comment:

  1. EDGARNovember 8, 2009 at 12:59 AM

    EXCELLENT!! You can reduce the spacing of in-between pipes to 30mm .

    ReplyDelete

Subscribe to: Post Comments (Atom)